可能有两种原因
1)笔帽密封不良, 想办法密封
2)供墨器(feed)太远离笔尖 用开水(火打火机)软化塑料,再把它轻微的弯向笔尖,注意不到位可以再弯,但不要过头. 上图!!!
Sometimes a "51" won't flow because the feed is too far away from the nib. This may have been the behavior that prompted Frank to say that the shell needs to touch the nib — thereby substituting the shell for the feed — but it’s better and more controllable to adjust the feed. Again, you’ll need to remove the nib (by removing the shell first). Remove the feed from the collector, heat it carefully just until it becomes soft enough to bend, and then bend the front half very slightly upward. Your bend should be a gentle curve just about midway along the feed’s length, as shown here:
Adjusted feed
(For visual clarity, this illustration shows the feed bent upward farther than you should actually bend it.)
As part of the changeover to the Aero-metric filling system, Parker eliminated the cut-back underside of the feed; the later version is cylindrical almost to the tip. These later feeds are less likely to need this sort of adjustment than are feeds like the one illustrated here.
摘自http://www.richardspens.com/作者: 心悦 时间: 2011-12-31 16:50
既然求追方便,那就用水笔吧,干嘛这么纠结作者: lipi521125 时间: 2011-12-31 17:04 回复 1#wsadwsad
凌美吧!换个墨水,没有问题,不会断墨作者: wangxin9903 时间: 2011-12-31 18:54
凌美出名的卖点之一不就是一笔出水么……
你的要求似乎就是在说凌美2000。作者: lxy20052005 时间: 2011-12-31 19:18 回复 23#方汀